EG2000 Electric Speed Controller Board Speed Govornor Brushless Motor
Universal Electronic Engine Governor Control Panel
The EG2000 is a universal generator governor / engine speed controller equipped with Smoke Limiting, & Idle Speed. Suitable for diesel, gas and natural gas engines with Built-in & Non-Built-in PTs Pumps, also can be used with Low Current, Electric over Hydraulic Oil Pumps Type Governor Actuators.
Features
- Works on a wide ranges of MPU/flywheel frequencies
- 15Amp Max Output
- Suitable for all types of diesel and Gas engines
- High Sensitivity and stable at Low Frequency Variations
- Moisture, vibration, and rust protected, Epoxy encapsulated electronics
- For Use With Isochronous Generators & Automatic Paralleling PLC controls
- Idle Speed Adjustment and connections for a Remote Speed POT
Specifications
| Operating Voltage |
10 VDC to 30 VDC |
| Output Current |
From 0.5 Amp to 15 Amp |
| Frequency Range |
600 Hz ~ 9500 Hz (PMG Signal) |
| Idle Speed Frequency |
Adjustable From 30~85% of normal |
| Speed Band |
± 0.25% at Steady State |
| Temp. Stability |
Between -40~85 °C Better than ± 0.5% |
| Remote Speed Adjustment Range (2 mode) |
Adjustable Range ± 5% with 5 KΩ potentiometer |
| Ramp Time |
3 to 20 Sec. Adjustable |
| Operation Environment |
- Vibration 3G @ 100~2KHz
- Relative Humidity Maximum 95%
- Operation Temp. -40~85 °C
- Storage Temp. -40~85 °C
|
| DIP Switch Description |
SW1 : ON 600~1200Hz
SW2 : ON 1200~2500Hz
SW3 : ON 2500~5000Hz
SW4 : ON 5000~9500Hz |
| Governor Controls |
DROOP : Droop Rate Adjustment
GAIN : MPU Output Gain Adjustment
Int. : Engine Stability Adjustment
RAMP-TIME : Soft Start Adjustment
SPEED : Speed Adjustment
IDLE : Idle Speed Adjustment |
| Dimension |
147.0 (L) x 114.0 (W) x 40.0 (H) mm |
| Weight |
690g ±2%
|
